INSTALLER
INSTALLATION MENU
|
| disabled zone. If enabled, an All On command activated from |
|
| another zone will turn on the enabled zone. |
3. | PARTY ENABLE - | This feature is either disabled or enabled. If disabled, Party Mode |
| (PtyEn) | activation from another zone will not affect the disabled zone. If |
|
| enabled (default), the zone will participate with Party Mode. |
4. | MASTER ENABLE - | This feature is either disabled or enabled. If disabled, the zone |
| (MstEn) | cannot host a master keypad during Party Mode. If enabled |
|
| (default), the zone has the option of hosting the Master keypad. |
5. | MUTE ENABLE - | This feature is either disabled or enabled. It allows the option of |
| (MutEn) | enabling or disabling muting in a zone. If disabled, the zone will |
|
| not mute. If enabled (default), the zone will be muted when a |
|
| mute signal is received. |
CTRLR SETUP (CtlId)
Controller Setup is the basic configuration of the controller. This setup menu selects the options for Controller ID and Factory Initialization. See Controller Setup - Flow Chart page 75
1. CONTROLLER ID - | This defines the Controller ID for this system. The default is 1 but |
(CtlId) | when multiple controllers are used, each additional controller ID |
| must be sequential and unique and be set before being connect- |
| ed to the system. Note that the system must be restarted before |
| the controller will assume the new ID. |
2. FACTORY INIT - | WARNING: This procedure returns the controller to its |
(FInit) | original settings - use with discretion. |
| Factory Initialization allows the installer to erase all programmed |
| settings and returns the settings to the factory default settings. |
| All settings including source equipment IR commands will need to |
| be reentered. An “Are you sure?” prompt and a “no” response |
| allows the installer to cancel the reset; a “yes” at the prompt will |
| load factory/default settings. |
POWER MANAGEMENT (PwMgt)
The CAM6.6 is capable of managing the power state of the connected source equipment. The power management is configured on a
62