Russound CAM6.6X-S1/S2 instruction manual Rnet Link In and Link Out

INSTALLER

MAKING CONNECTIONS

RNET Link In and Link Out

The RNET Link In and Link Out is used to con- nect two or more CAM6.6 or CAV6.6 con- trollers. The connection is made using a CAT-5 patch cable from the Link Out of the master CAM6.6 and into the Link In of the next con- troller. Along with RNET data signals, the RNET Link In and Link Out jack passes the six source IR signals. These are only for source-specific IR remote repeating, not codes initiated from the controller’s internal IR library. The CAT-5 patch cable should not exceed 18 inches in length to avoid potential cross-talk between the source- specific IR repeating signal lines.

The RNET Link In and Link Out is also used to connect the CAM6.6 to other Russound prod- ucts with RNET.

Note: If two or more CAM6.6 or CAV6.6 con- trollers will be connected using the RNET Link In and Link Out ports, each controller must have a unique Controller ID prior to being connected through the RNET ports. The Controller ID assignment must be performed during the Controller Setup section of the Installation menu.

CAM6.6 (Controller ID 1)

LENGTH 18 inches)	ANTENNA	CAM6.6
CAT-5 Cable (MAX	CAV6.6 (Controller ID 2)

43