Zone On/Off
Press and release 
to turn on the UNO System Keypad. This also turns on the corre- sponding CAM6.6’s room, and any presets previ- ously assigned will be activated, including set- tings for bass, volume, last source selected,
etc. Press and release 
to turn off the UNO System Keypad. This will also put the corresponding CAM6.6’s room into a standby state.
System All On/Off
An “All On” command is issued by pressing 
and holding for 3 seconds, after an initial room has been turned on. An “All Off” command can be issued to all rooms by pressing and holding 
after the room has been turned off.
System On Indicator
When the room is off, but the system is on in
another room, 
is illuminated by a green backlight and the "SYS ON" icon remains visible.
Source Select Button
scrolls through the six A/V source inputs. To
change sources, press and release 
. As the sources are sequentially selected, each source's name appears on the keypad LCD panel. When a source is selected in more than one room, the “SHARED” icon will appear on all UNO Keypads using that source.
USER
OPERATION
UNO-S2 Keypad
is also used to enter the User Menu with a press and hold action. (See next page for User Menu)
Volume Up/Down Buttons
The room’s audio output is adjusted using 
.
F1 and F2 Buttons
The | and | buttons are user favorite pre- |
sets. These presets can be selected at any time to recall source selection, volume, and favorite channel, disk, etc. To store a favorite preset: first, adjust the room settings and select a source to be
stored. Next, press and hold the desired | or |
button until SAVED is displayed on the LCD
panel. Now a press and release of the button will recall the favorite preset. To set a favorite num-
bered disk or channel, use | or | to select a |
disk or channel (e.g., channel 45). Wait for the keypad to show the source name, then press and hold the F1 or F2 within 15 seconds of set- ting the numeric selection to save the setting.
Command Keys
The command keys allow control of the selected source at the UNO Keypad. The command keys are activated with a press and release, or press and hold to access secondary functions.
13
