| INSTALLER |
| INSTALLATION MENU |
2. KEY FUNCTION – | Select the function to be learned or deleted. |
(KeyFn) |
|
3. LEARN/DELETE – | Select Learn IR Now or Delete IR. If Learn IR Now, a “USE |
(Ln/Dl) | REMOTE” prompt appears. Point the learning remote at the |
| controller’s IR window. If Delete IR, procedure returns to |
| LEARNED SRC (step 1) |
4. TEST IR? – | If “yes,” sends the learned command to the source component |
(TstIR) | to test the IR. If the component responds, the IR test was a |
| success. If the component does not respond the Code was not |
| learned properly. If “no,” menu goes back to LEARNED SRC |
| (step 1) |
5. SUCCESS? - | Asks if the IR test was a success |
(OK?) |
|
| IF YES - If the test was a success, specify “yes” and proceed to |
| KEY FUNCTION (step 2) |
| IF NO - If the test was a failure, specify “no” and LEARN/DELETE |
| (step 3) reappears on the display allowing another code to be |
| learned in. |
MACRO EDITOR (MacEd)
This procedure is used to create a sequence of commands that are launched with one key touch or other event. Up to 132 macros can be created for the system, and each macro can contain up to 10 commands including other macros and delays. See Macro Editor - Flow Chart page 78
1. | MACRO ID – | Number of Macro up to 132 including any previously named |
| (MacID) | macros. |
2. | MACRO NAME – | Name of Macro (optional). |
| (MacNm) |
|
3. | COMMAND NUM – | Number of Command up to 10. |
| (Cmd#) |
|
4. | COMMAND TYPE – | Select the type of source command (e.g., CD, TV, etc.). |
| (CmdTp) |
|
| a. Selected: Learned IR | Choose Learned IR if the |
| (LrnIR) | not support the source component. |
| i. LEARNED SRC – | Select the learned source bank to be assigned to the source |
| (LnSrc) | component. Procedure advances to KEY FUNCTION (step 6) |
65
