Using the OCAP (OpenCable Application Platform) Data Service
Connecting CableCARD
You must obtain a CableCARD from a local cable service provider.
ANT 1 IN (CABLE)
1.Plug the incoming cable into the ANT 1 IN (CABLE) terminal on the back of the TV.
The CableCARD recognizes input signals from ANT 1 IN (CABLE).
TV Rear Panel |
Please insert the |
card as shown. |
2.Insert the CableCARD into the “CableCARD” slot and the message “CableCARDTM‚ Inserted” is displayed.
In order to start service for this device, please contact customer sevice at PH# 888
CableCARD(tm):
Host ID:
MAC ID Number
Serial Number
Weak or no signals.
Updating Channel List
TIME WARNER
C A B L E
3.Within a few minutes after step 2, the message is displayed with a phone number to call for activating the CableCARD. This message contains the CableCARD ID and Host ID numbers of your TV, which records these numbers in preparation for activation.
4.After activation, the cable provider will send activation messages to the CableCARD. During this operation, the message “Updating Channel List” is displayed. When the “Updating Channel List” process is completed, the message “Updating Completed” is displayed and your TV will switch to an active channel.
5.Within a few minutes after step 4, the message “Receiving Data Service Signal” is displayed and disappears.
6.The TWC ODN loading screen is displayed. (Loading screen number start from 14 to 1.)
Initializing, please wait...
14
