Samsung RM255BABB Initial Operation, Reverse rotation CCW Forward rotation CW Ice extraction

OPERATING INSTRUCTIONS & INSTALLATION

3-8) ICE-MAKER Function (applies only for model with dispenser function)

This ICE-MAKER function is option specification so as to be drawn to the function explanation for relevant model.

ICE-MAKER is model attached with unit equipment where is furnished function of automatic ice making so that ice may be made in container inside the freezer compartment and may be drawn out by using ice dispenser under storage status ==> The equipment.

1)Initial Operation

This is operation at initial “power on” or at that after “power off” due to electricity interruption which operation is to restore to horizontality by revolving ice extraction motor.

1-1) At first no operation is performed for 2 seconds after initial power on or after power returns after a momentary power outage. But after that, an initial horizontality operation of the ice extraction is performed.

2-1) Because the condition of the ice maker is unknown, first the ice extraction motor is turned in the reverse direction to let it come to its most horizontal position possible. The judgment of horizontal position is done by the ice extraction S/W. If this S/W is on for more than 2 seconds during the reverse rotation of the ice extraction motor, then it is judged that the transition to the most horizontal position possible has been made and the ice extraction motor is stopped (1). It waits a second in this condition.

3-1) Because condition 2-1) is an upset twisted condition caused by the reverse direction rotation of 2 seconds after sensing the horizontal position, the motor revolves in the forward direction for 200 ms after ice tray S/W off (2) and then It waits 1 second.

4-1) Finally to achieve horizontality, the ice tray motor turns again in the reverse direction but it will stop immediately if the ice tray S/W comes on (3), which condition may be interpreted as the horizontal

5-1) The standby condition is maintained for 2 hours regardless of any conditions after Ice-Tray horizontality operation. Therefore, under the initial power on condition, there is no movement for 2 hours except for the ice tray horizontality operation.

6-1) Ice is made if the ice making temperature has been reached according to the ice tray temperature check after a 2 hours wait period (initial ice extraction mode).

Reverse rotation : CCW

Forward rotation : CW

(1)

(2)

(3)

Ice extraction

S/W

Signal generated by ice inspection lever when returning to horizontal position

Instrumental lock position

Horizontal position

Interval about

880ms

S/W cognition debounce is taken about 2 seconds at time of reverse rotation of interval (1) so as not to mistake this interval as horizontal position

Instrumental lock position

Maximum torsion point

Figure- Horizontal movement operation at initial power on of the product (referes to ice extraction S/W)

20

18