Samsung RM255BABB Trouble, Cf-Sensor, CF-FAN Error, CR-FAN Error, ICE Pipe, Communicati, On Error

OPERATING INSTRUCTIONS & INSTALLATION

No	ITEM	TROUBLE	REMARK
16	F-DEF-SENSOR	Electric wire cut, short-circuit, contact failure, sensor housing missing, while in case
		of displaying a temperature defect, it is only displayed when sensor detection
		temperature is not lower than 122 nor higher than -58	￿
		Error is displayed in case there is a contact failure on the feedback signal line,

17F-FAN ERROR motor wire missing or defect of the motor itself, when operating the relevant

fan motor.

Error is displayed in case there is contact failure on the feedback signal line,

18C-FAN ERROR motor wire missing or defect of the motor itself when operating the relevant

			fan motor.
19	CF-SENSOR		Electric wire cut, short-circuit, contact failure, sensor housing missing, while in
			case of displaying a temperature defect, it is only displayed when sensor
			detection temperature is not lower than 122 nor higher than -58
20	F-DEFROSTING		Error occurs and is displayed when regarding the F compartment defrosting heater, there is a electric wire
			cut, short-circuit, contact failure, of sensor housing missing, or defective temperature fuse. A defect is
	ERROR
			displayed if defrosting is not finished after continuous heating for more than 80 min, for the F compartment.
21	CF-FAN ERROR		Error is displayed in case there is a contact failure on the feedback signal line,
			motor wire missing or defect of the motor itself, when operating the relevant fan
			motor.
22	CR-FAN ERROR		Error is displayed in case there is a contact failure on the feedback signal line,
			motor wire missing or defect of the motor itself, when operating the relevant fan
			motor.
23	-
24	ICE PIPE		Error is displayed in case of ice pipe heater housing missing or
	HEATER ERROR		electric wire cut.
25	Uart
	COMMUNICATI		Communication error with the electric power cord MODEM
	ON ERROR
26	L	M COMMUNICATI	Whole letters of the LCD panel repeat ON/OFF and buzzer generates alarm sound
			if communication between MICOM MAIN LOAD is not achieved due to an
	ON ERROR
			interruption of more than 10 seconds.
27	P	M COMMUNICATI	Whole letters of the LCD panel repeat ON/OFF and buzzer generates alarm sound
	ON ERROR		if communication between MICOM MAIN PANEL is not achieved due to an
			interruption of more than 10 seconds.

30