DISASSEMBLY AND REASSEMBLY
Evaporator in Fridge
The evaporator is located in the bottom of the refrigerator.
1.Take off the partition in the refrigerator.
2.Take off the evaporator cover in the refrigerator.
3.Disconnect the wire connector.(Heater and Thermistor)
4.Desolder the capillary tube and the suction line from the evaporator.
5.Remove the evaporator.
6.With a file, score the capillary tube just upstream of the soldered point. Break off the soldered section to help prevent solder from plugging the tube during soldering.
7.Place a new evaporator and braze the suction and capillary tube to the evaporator using silver solder.
8.Install a replacement dryer.
9.Evacuate and recharge the system using reasonable procedures.
Capillary Tube
Suction Line
Thermistor
Bimetal
Refrigerator Thermistor
The refrigerator thermistor is located inside the refrigerator light cover
1.Put your finger into the side groove of the lamp cover,and pull the cover to separate.
2.Remove the screw in the lower part of Ductwork,and pull the Thermistor cover.
3.Separate the housing inside the of Thermistor cover, and replace the sensor.
Ductwork
Thermistor
Thermistor cover
Fresh /Arctic Select ZoneTM Thermistor
Fresh/Arctic Select Zone Thermistor is located in the lower part of evaporator cover
1.Unscrew both sides of the Thermistor cover.
2.Remove Thermistor cover by pulling it out.
3.Remove the tapes inside of cover, and remove the front side Insulation to replace the Thermistor.
Thermistor cover
Thermistor
56
