Troubleshooting
Troubleshooting
Problem |
| Action | |||||
|
|
|
|
|
| ||
| • Plug the power cord into a live electrical outlet. | ||||||
| • Check the fuse or reset the circuit breaker. | ||||||
|
|
|
|
| |||
| • | Close the door and press |
|
|
| Start/Pause to start the washing | |
|
|
| |||||
|
| machine. For your safety, the washing machine will not | |||||
|
| tumble or spin unless the door is closed. | |||||
| • Before the washing machine starts to fill, it will make a series | ||||||
|
| of clicking noises to check the door lock and does a quick | |||||
Stops. |
| drain. | |||||
• There may be a pause or soak period in the cycle. Wait briefly | |||||||
| |||||||
|
| and the washing machine may start. | |||||
| • Make sure the mesh filter of the water supply hose at the | ||||||
|
| water taps is not clogged. Periodically clean the mesh filter. | |||||
| • If the washing machine is not supplied with sufficient power, | ||||||
|
| the washing machine temporarily will not drain or spin. As | |||||
|
| soon as the washing machine regains sufficient power, it will | |||||
|
| operate normally. | |||||
|
|
|
|
|
| ||
| • Fully open both taps. | ||||||
| • Make sure the temperature selection is correct. | ||||||
| • Make sure the hoses are connected to the correct taps. Flush | ||||||
|
| water lines. | |||||
| • Make sure the water heater is set to supply a minimum 120 | ||||||
|
| °F (49 °C) hot water at the tap. Also, check the water heater | |||||
|
| capacity and recovery rate. | |||||
Fills with the wrong | • Disconnect the hoses and clean the mesh filter. The mesh | ||||||
| filter may be clogged. | ||||||
water temperature. |
| ||||||
• While the washing machine fills, the water temperature may | |||||||
| |||||||
|
| change as the automatic temperature control feature checks | |||||
|
| incoming water temperature. This is normal. | |||||
| • While the washing machine fills, you may notice just hot and/ | ||||||
|
| or just cold water going through the dispenser when cold or | |||||
|
| warm temperatures are selected. This is a normal function | |||||
|
| of the automatic temperature control feature as the washing | |||||
|
| machine determines the water temperature. | |||||
|
|
|
|
|
| ||
| • Use the High or Extra High spin speed. | ||||||
Load is wet at the | • Use high efficiency (HE) detergent to reduce oversudsing. | ||||||
• Load is too small. Small loads (one or two items) may become | |||||||
end of a cycle. | |||||||
| unbalanced and not spin completely. | ||||||
|
| ||||||
| • Make sure the drain hose is not kinked or clogged. | ||||||
|
|
|
|
|
|
| |
50 English
|
| ||
|
| ||
|
|
|
|