4OPERATIONS IN SEARCH MODES
5. MOTION DETECTION SEARCH
By setting images recorded in the hard disk’s normal recording area or alarm recording area to the motion sensor, variations from these images as a result of the presence of an intruder or the like can be detected, and the corresponding images can be played back.
(4) (6)
(1)
(2)
(3) 
(5)
(7) (8)
(1) SEARCH FROM
The recording area to be used for motion searching
(2) CHANNEL
The channel or camera number to be used for motion searching
(3) START/END
The date and time of the start and end of the memory area for motion searching
(4) [SET]
Detection condition settings
(5) Message box
This box displays the results of searching for motion- detection images
When searching | “SEARCHING” | |
|
| |
When | “FOUND!” | |
images exist | ||
| ||
|
| |
When | “IMAGES NOT FOUND!” | |
images do not exist | ||
| ||
|
|
(6) MOTION SENSOR SET
Screen for making motion sensor settings
(7) MOTION SENSOR LEVEL
Motion sensor sensitivity setting: OFF or 1 through 10 (Lower numbers correspond to higher levels of sensitivity.)
(8) [PREVIEW]
Displays a preview of the detection image
1 Select “5. MOTION DETECTION SEARCH” from the SEARCH menu.
The motion detection search screen is displayed.
2 Specify the recording area to be used for motion searching from “SEARCH FROM”
[Settings] ( indicates default setting.)
Setting | Description | |
ALARM | Searching will only be performed for images | |
in the alarm recording area. | ||
| ||
NORMAL | Searching will only be performed for images | |
in the normal recording area. | ||
| ||
ALARM AND | Searching will be performed for images in the | |
alarm recording area and normal recording | ||
NORMAL | ||
area. | ||
|
3 Specify the channel (or camera number) for searching from “CHANNEL” pull- down menu.
If the number of channels is one,
4 Click [SET].
The date and time of the start and end of recording of motion detection images is displayed in “START” and “END” respectively.
zUse “START” and “END” to make new date and time settings when the searching range is to be reduced.
zThe results of searching will be displayed in a message box when [SET] is clicked.
5 Setting motion sensor detection conditions.
zMotion sensor positions
The motion sensor setting screen shows an 8 x 10 (height x width) grid of sensors, and when one of these sensors is clicked, the corresponding sensor setting mark will turn red. If the same location in the grid is clicked once again, the motion sensor will be deselected.
zMotion sensor sensitivity
Lower numbers correspond to higher levels of sensitivity, and a setting should be made from the pull- down menu.
6 Click [PREVIEW].
A search is carried out within the specified area for images in which motion was detected, and these images are then listed in recording sequence in the preview screen.
7 Click the preview screen for the image to be played back.
NETWORK OPERATION
36 | English |
