SATO CL608VA, CL612VA manual HOR. Offset, Direction Label Edge Label Feed Inside

Section 2. Installation and Configuration

1.Use the LINE key to step the underline to either the positive (+) or negative (-) selection. A positive selection increases moves the horizontal reference point for the label to the right edge of the label, towards the outside, while a negative selection moves the horizontal reference point for the label to the left, towards the inside of the printer.

2.Once the correct direction setting is underlined, pressing the FEED key will accept the setting and advance to the Horizontal Offset adjustment.

HOR. OFFSET

H+ 0000

3.Use the LINE key to step the counter to the desired setting. The display will increment one step for each time the LINE key is pressed. If the LINE key is held pressed for more than two seconds, it will automatically go into the fast scroll mode. The reading will advance to the maximum setting setting (the maximum Horizontal Offset) after which it will automatically wrap and start at “0000” again. The Horizontal Direction set in the previous step will be displayed in front of the Offset setting.

	CL608	CL612	CL408	CL412
Horizontal Offset	+/-1216	+/-1984	+/- 832	+/-1248

Note: The CL printers will not “wrap” images that extend beyond the print area. Any part of the image that extends beyond the print area will be truncated.

4.Once the setting is correct, pressing the FEED key will accept the setting and advance to the Sensor Threshold display.

	ABCDEFG
	ABCDEFG
Direction	Label Edge
Label Feed	Inside
SATO CL Series Printers	9001035 Rev. E

Original Print

Line Position

Moved with both Vertical and (+) Horizontal Offset

Page 2-31