SATO CL608VA, CL612VA Sato CL Programming Language, ESCCommand Data, ESCCommand Parameter

SECTION 4.

PROGRAMMING

INTRODUCTION

This section presents the commands that are used with the SATO CL Series printers to produce labels with logos, bar codes and alphanumeric data. All of the CL commands use the same syntax. Some commands reference a physical point on the label using horizontal and vertical dot reference numbers. The allowable range for these references is dependent upon the particular printer to accomodate different print widths and resolutions. These differences are noted in tables under the commands affected.

The following information is presented in this section:

∙The SATO CL Programming Language

∙Selecting Protocol Control Codes

∙Using Basic

∙The Print Area

∙Command Codes

THE SATO CL PROGRAMMING LANGUAGE

A programming language for a printer is a familiar concept to most programmers. It is a group of commands that are designed to use the internal intelligence of the printer. The commands, which are referred to as CL Command Codes, contain non-printable ASCII characters (such as <STX>, <ETX>, <ESC>) and printable characters. These commands must be assembled into an organized block of code to be sent as one data stream to the printer, which in turn interprets the command codes and generates the desired label output. The programmer is free to use any programming language available to send the desired data to the SATO CL Series printer.

The command codes used by the SATO CL Series Printers are based upon “Escape”

(1B hexadecimal) sequences. Typically there are four types of command sequences:

<ESC>{Command}

These commands generally tell the printer to perform a specific action, like “clear the memory.”

<ESC>{Command} {Data}

Commands with this format tell the printer to perform a specific action which is dependent upon the following data, like “print X labels”, where the value for X is contained in the data.

<ESC>{Command} {Parameter}

SATO CL Series Printers 9001035 Rev. E Page 4-1