SATO LM408/412E manual Dipswitch Settings

Unit 4: Printer Configuration

DIPSWITCH SETTINGS

This chapter identifies the functions of the printer’s integrated dipswitches. The dipswitch complex is located on the printer’s operator panel and is an integral part of its configuration by enabling/disabling various operational features. Refer to the table below on switch designation and their specific functions.

ATTENTION: Each dipswitch must be set for the printer to properly function. Address all eight switches individually, but some may not require change.

NOTE: A small, flat tool similar to a screwdriver is required to alter dipswitch position.

When changing a switch setting, ensure that it has been moved fully up or down.

NOTE: The switches are arranged horizontally, from left to right, and oriented vertically. The ON position is always upward and the OFF position is always downward.

DIPSWITCH FUNCTIONS

SWITCH	SETTING	DESCRIPTION
1	ON	Direct Thermal Printing
	OFF	Thermal Transfer Printing
2	ON	Enable Eye-Mark Sensor
	OFF	Enable Gap Sensor
3	ON	Enable Headcheck Feature
	OFF	Disable Headcheck Feature
4	ON	Enable Hex Dump Feature
	OFF	Disable Hex Dump Feature
5	ON	Enable Multi-Buffer Interface Receive Mode (periodic response)
	OFF	Enable Single-Buffer Interface Receive Mode (ENQ response)
6	ON	Enable Download Mode Feature
	OFF	Disable Download Mode Feature
7	ON	Enable Control Code Feature
	OFF	Disable Control Code Feature
8	ON	Enable 203dpi Print Resolution
	OFF	Enable 305dpi Print Resolution

LM408-412e Operator Manual 4-3 PN: 9001155A