Unit 4: Printer Configuration

HISTORY CONTROL MODE

When enabled, the History Control Mode uses the printer’s recent operational history as a way to control the heating temperature of head elements when printing the next label. This is performed by using previous print activity as way to automatically extrapolate the electricity required to reach the temperature needed and supplying only amount.

Conversely, the Firmware applies electricity to the print head to heat its print elements based on the assumption that the print head is cool and freshly powered on. However, after a few print cycles, the print head retains heat from previous print activity and requires time to cool down. If the Firmware continues to assume the print head has cooled down to ambient temperature instantly after every print cycle, then the electricity it applies to the print head would theoretically be excessive and result in overheating of the ribbon.

Use the keys of the printer’s operator panel to select and enter the required options. Refer to the Menu Definition Tables in the following chapter to provide an explanation of each menu screen.

DSW4: ON

LINE + POWER

Scrolls options

HISTORY CONTROL

ON OFF

LINE

FEED

HISTORY CONTROL

COMPLETED

Power printer off, reset DSW4 to exit

Figure 4-7, History Control Mode

LM408-412e Operator Manual

4-10

PN: 9001155A

Page 41
Image 41
SATO LM408/412E manual History Control Mode