Appendix
154
9
Limitation
❒There may be a difference in the size of the image when it is printed at the des-
tination.
❒If you set an original larger than DLT /A3 on the exposure glass, only an area
of DLT /A3 is scanned.
Note
❒Even if an original is correctly placed on the exposure glass or in the Docu-
ment Feeder (ARDF), a margin of 3mm around each edge of the original may
not be sent.
❒If the receiver uses paper narrower than the original, the image will be re-
duced to fit the paper width.
❒The machine detects paper sizes in the following ways.
•When you set an original in the Docume nt Feeder (ARDF), an orig inal wid-
er than about 10.4" (263mm) is scanned as 11"×17" size.
An original narrower than about 9.1" (230mm) will be sent as 81/2"×11" or
81/2"×14" size.
Originals up to 17” (432mm) in length can be scanned.
•Refer to the table below for the sizes the machine can detect when you set
an original on the exposure glass. Because the machine scans in non-stand-
ard size documents as one of the standard sizes, parts of the image may be
truncated depending on the length of the document. For how to set non-
standard size documents, see P.45 “Choosing the Area to be Scanned Yourself
(Irregular Scan Area)”.
-
--
-Maximum Scan Area
Memory Transmission/Immediate Transmission
•From the Document Feeder (ARDF): 11"×17"/297×432mm (W×L)
•From the exposure glass: 11"×17"/297×432mm (W×L)
Length
width
∼”9.80 ”9.80∼ ”10.79 ”10.79∼
”12.44
”12.44∼
∼”9.57 not detected LTLLTLLGL
”10.55∼ LTKDLTLDLTLDLTL