Printing Functions
27
2
Note
❒Your service representative can
customize this feature with the fol-
lowing settings. Bracketed values
are defaults.
•Reduction (on)
•Print split mark (on)
•Overprinting (on)
•Overprinting length (10mm)
•Guideline for split (when mes-
sage is 20mm longer than pa-
per)
❒You can adjust the overprinting
and reduction lengths within the
following ranges:
•Guideline for split: 0∼155mm
(5mm steps)
•Overprinting length: 4mm,
10mm, 20mm, 40mm
Reverse Order Printing
Normally, received pages are printed
and stacked on the tray in the order
they are received. If you turn this fea-
ture on, the machine will start print-
ing the message from the last page
received.
Note
❒By default, this feature is turned
off. Switch it on with the Initial Set-
up RX. ⇒ P.90 “Initial Setup RX”
❒When this feature is on, the first
page will be printed last.
❒This feature uses Memory Recep-
tion.
Page Reduction
If you turn this feature on and you re-
ceive a message that is longer than the
paper in the cassette, usually the ma-
chine prints it on two pages. The ma-
chine reduces the width and length of
the received image so that it will fit on
one page. If A4L paper size is loaded
and a message of B4 L size is re-
ceived, the machine will reduce the
message to a single A4L sheet.
Note
❒By default, this feature is turned
off. Switch it on with the User Pa-
rameters. ⇒ P.130 “Changing the
User Parameters”(Switch10, Bit3)
Reference
P.26 “Page Separation and Length Re-
duction (Not Available in Some Coun-
tries)”
your machine
Print
ND1X01E2
Nd1x01e2.eps
your machine
reduction
(A4 size)
(B4 size)
ND1X01E3
Nd1x01e3.eps