Reception Features

20

2
-
--

-Sending the Transfer Result

Report

This machine compares the fax
number of the Requesting Party with
the Requesting Party's number pro-
grammed in a Quick Dial or Speed
Dial, If the lower five digits of the two
numbers match, it sends the Transfer
Result Report to the Requesting Par-
ty.
For example:
•Requesting Party's own dial
number:
001813-11112222
•Transfer Station's Quick Dial:
03-11112222
Transfer Result Report
This reports whether transmission to
the End Receivers was successful or
not.
Preparation
Register the own fax number in ad-
vance. ⇒ P.7 “Changing the Line
Type”
When the Transfer Station has trans-
ferred the message to all End Receiv-
ers, it sends the Transfer Result
Report back to the Requesting Party.
The machine prints the report if it
cannot be sent back to the Requesting
Party. You must program the fax
number of the requesting party in a
Quick Dial or Speed Dial in the Trans-
fer Station. See Chapter3, “Register-
ing QuickDials” or “Registering
SpeedDials” in the Basic Features
manual.
Note
❒By default, a portion of the original
image is printed on this report.
You can turn this off with the User
Parameters. ⇒ P.130 “Changing the
User Parameters”(Switch04, Bit7)
ID Reception (Closed Network)
If you wish to limit reception of mes-
sages from those with the same ma-
chines of the same make and with the
same Polling ID, contact your service
representative to turn this feature on.
F Code (SEP)
Normally you can only use Polling
Reception to receive faxes from ma-
chines that have the Polling Recep-
tion feature of the same make.
However, if the other machine of an-
other make supports a polling recep-
tion, you can receive fax messages
from the other party using this meth-
od instead.
Preparation
You need to assign the F Code fea-
ture to a User Function key before-
hand. ⇒ P.94 “Storing/Editing the
Contents of a User Function Key”
Limitation
❒You can only use this feature with
a G3 line (not with G4).
❒You cannot use Chain Dial with
this feature.