Polling Transmission
49
3
BEnter the 4 character Polling ID
with letter keys/ number keys.
Note
❒If you make a mistake, press
the {Clear/Stop} key and try
again.
0000 and FFFF is not available.
CPress [S
SS
SFile] and specify wheth-
er to save the stored original.
Each time you press the key, the
text at the middle right corner of
the display toggles between
“Save” and “Use once”.
Note
❒To delete the original imme-
diately after transmission, se-
lect “Use once”.
❒To repeatedly send the origi-
nal, select “Save”.
EPress [OK].
The Transmission Mode menu is
shown. A check mark is added to
“Polling TX”.
Note
❒To cancel the Polling Transmis-
sion, press [Cancel]. The Trans-
mission Mode menu is shown.
FPress [Exit].
The initial display is shown.
Note
❒“Polling TX” is displayed. If
you set up another advanced
transmission function (except
Polling Reception), “Others” is
displayed.
GPress the {
{{
{Start}
}}
} key.
Polling Transmission Clear Report
This report allows you to verify
whether Polling Transmission has
taken place.
Limitation
❒This report is not printed if the
User Parameters are set to allow
the stored originals to be repeated-
ly sent (Save). ⇒ P.130 “Changing
the User Parameters”(Switch11,
Bit7)
Note
❒This report is turned on by default.
You can turn it off if you wish. ⇒
P.130 “Changing the User Parame-
ters”(Switch11, Bit7)
❒By default, a portion of the sent im-
age is printed on the report. You
can turn this off with the User Pa-
rameters. ⇒ P.130 “Changing the
User Parameters”(Switch04, Bit7)
❒You can also check the result of a
Polling Transmission with the
TCR.
Us95-4.tif
Us95-6.tif
Us96-1.tif
Us96-2.tif