6. Configuration
bControl via Modbus in Drivecom profile
The command and reference come from Modbus.
The command is in Drivecom profile.
Configure the following parameters:
Parameter | Value | Comment |
Profile | Drivecom profile not | The run commands are in Drivecom profile, the command and the reference |
| separate | come from the same channel. |
Reference 1 configuration | Network card | The command comes from Modbus. |
|
|
|
Configuration via the graphic display terminal or the integrated display terminal:
Menu | Parameter | Value |
[1.6 - COMMAND] | [Profile] (CHCF) | [Not separ.] (SIM) (factory setting) |
|
|
|
| [Ref. 1] (Fr1) | [Com. card] (nEt) |
|
|
|
bControl via Modbus or the terminals in Drivecom profile
Both the command and reference come from Modbus or the terminals. Input LI5 at the terminals is used to switch between Modbus and the terminals.
The command is in Drivecom profile.
Configure the following parameters:
Parameter | Value | Comment |
Profile | Drivecom profile not separate | The run commands follow the Drivecom profile, and the command and |
|
| reference come from the same channel. |
Reference 1 configuration | Network card | Reference 1 comes from Modbus. |
|
|
|
Reference 2 configuration | Analog input 1 on the terminals | Reference 2 comes from input AI1 on the terminals. |
|
|
|
Reference switching | Input LI5 | Input LI5 switches the reference (1 ↔ 2) and the command. |
|
|
|
Caution: Reference 2 is directly connected to the drive reference limit. If switching is performed, the functions that affect the reference (summing, PID, etc) are inhibited.
Configuration via the graphic display terminal or the integrated display terminal:
Menu | Parameter | Value |
[1.6 - COMMAND] | [Profile] (CHCF) | [Not separ.] (SIM) |
|
|
|
| [Ref.1 channel] (Fr1) | [Com. card] (nEt) |
|
|
|
| [Ref.2 channel] (Fr2) | [Ref. AI1] (AI1) |
|
|
|
| [Ref. 2 switching] (rFC) | [LI5] (LI5) |
|
|
|
16
