Schneider Electric XPSMF2DO801 manual Following table contains the parameter descriptions

	Brief description of the functional devices
The following table contains the parameter descriptions:
Parameter	Description
Port	Port number, as assigned on device.
	Note: Only 1 configuration is possible per port.
	Value range 1...n, depending on the resource
Speed [MBit/s]	The following selections are available:
	10 MBit/s data rate 10 MBit/s
	100 MBit/s data rate 100 MBit/s
	Autoneg (10/100) automatic setting of the baud rate
	The default setting is Autoneg.
Flow control	The following selections are available:
	Full duplex communication in both directions at the same time
	Half duplex communication in one direction
	Autoneg automatic control of communication
	The default setting is Autoneg.
Autoneg also with	The Advertising (transfer of Speed and Flow control properties) is
fix values	made with fixed parameter values. Thereby other devices, whose port
	settings are Autoneg, can recognise how the PLC ports are set.
Limit	Limit incoming Multicast and/or Broadcast packages.
	The following selections are available:
	Off no limit
	Broadcast limit Broadcast (128 kbit/s)
	Multicast and Broadcast limit Multicast and Broadcast (1024 kbit/s)
	The default setting is Broadcast.

Activation of Parameters are set in the COM window of the Hardware Management screen.

Settings Before the changes/settings become active the application program must be compiled using the Code Generator and then transferred to the PLC(s). The communication properties can be changed in the online mode using the Control Panel. The settings become active immediately, but are not transferred to the application program.

33003405 07/2007 75