ASSEMBLY
Assembly requires two persons. To assemble the CROSS TRAINER e, use the included videocassette or follow the instructions below. Due to the weight oFthe CROSS TRAINER e, it should be assembled in the location where it will be used. Place all ports in o cleared area and remove the packing materials. Do not dispose of the packing materials until assembly is completed. Make sure to lower the resistancecylinders and pedals before beginning assembly; if the resistance cylinders fall, they may damage the side shields. Read each assemblystepand examine each drawing carefully. Make sure that all ports are oriented as shown in the drawings.
Thefollowing tools (not included)are required for ass_'nbly:two 8'Adjustable Wrenches _ | and a | |
RubberMallet _. | Theincludedlubricantand a smallamount of soapywater are also required. | |
1.Set the Front Base (7) and the Rear Base (8) on the floor as shown. Turn the Rear Base so the indented holes are toward the Floor.
Insert seven3/8" x 2 1/2" Carriage Bolts (1) up through the indicated holes in the Front and Rear Bases (7, 8).
7
2. With the help of o second person, set the Tower | 2 |
Frame (10} near the indicated ends of the Front and Rear Bases (7, 8). The Tower Frame mustbe turned so the Pedals (75, 76) are on the someside as the extension on the Front Base. Raise the Tower Frame and lower it onto the two indicated 3/8" x 2 1/2" Carriage Bolts (1) in the Rear Bose.
,Raise the front of the Tower Frame (I O) and lower it onto the two indicated 3/8" x 2 1/2" Carriage Bolts
(1) in the Front Base {7). | 3 | 2 | . | 2 | |
Adjust the position o_ the Tower Frame (10) so the |
| 10 j. | s | ||
four indlcoted | 3/8 _'x 2 1/2" | Carriage Bolts (1) are |
|
|
|
centered in the slotted holes in the Tower Frame. |
|
|
| ||
Thread a 3/8" | Nut (2) with |
|
|
|
|
onto each Carriage Bolt. Do not tighten the Nuts |
|
|
| ||
yet. |
|
|
|
|
|
3
