14.Attach the Seat (28) to the Upright (9} with the two 1/4" x 3/4" Bolts (20) and a 1/4" x 2 1/2" Bolt
(46).
15.Center one Pad Tube (22) in the Upright (9), and the other Pad Tube in the Leg Developer (23). Slide the four Small Pods (17) onto the ends of the Pad Tubes.
16.Rest the Leftand Right Pedals (75, 76) on the hooks at the lower ends of the Resistance Cylinders (84). Make sure that the hooks are fully inserted into the same slots under both Pedals.
Plug the TransFormer (39) into the jack located near the bottom of the Right Side Shield (12).
17.Make sure that oil ports are properly tightened. The use of oil remaining PoX will be explained in ADJUSTING THE CROSSTRAINER e, beginning on page 8 oFthis owner'smanual.
18.Before using the CROSS TRAINER e, test the cables and the pulleys. Make sure that the cables are in the grooves in the pulleys. If the cables do not move smoothly over the pulleys, locate and correct the problem before using the CROSS TRAINER e. If the'€':ablesare not properly routed, they will be damaged when used.
7
