14 - 4 CLEANING THE MONITOR GLASS

Removing the Monitor Glass requires complicated work. Clean the Front Glass only in the weekly cleaning. To clean the Reverse Glass of the Monitor and the CRT Surface, removing the Monitor Glass is required.

FRONT MONITOR GLASS

1Take out 2 screws to remove the Boss Cover.

2Take out 10 screws to remove the Control Panel Upper. If it is hard to take out the screws due to the existence of the Steering Wheel, remove the emblem and the Steering Wheel ahead of time.

3Take out 4 screws to remove the Control Panel Bracket Upper.

4Take out a total of 6 screws, and remove each of Glass Holder Upper Center, Glass Holder Upper Lower, and Glass Sash.

GLASS HOLDER UPPER CENTER

GLASS SASH

GLASS SASH

GLASS HOLDER LOWER CENTER

CONTROL PANEL BRACKET UPPER

CONTROL PANEL UPPER

TRUSS SCREW(6 in total),black

M4 X 16,flat washer used

SCREW(4)

M4 X 16,w/flat & spring washers

BOSS COVER

TRUSS SCREW(2),black

M4 X 8

TRUSS SCREW(10),black M4 X 12,flat washer used

FIG. 14. 4 a

5Take out the Monitor Glass.

FIG 14. 4 b

MONITOR GLASS

www.seuservice.com54

Page 61
Image 61
Sega F355 owner manual 14 4 Cleaning the Monitor Glass, Front Monitor Glass