Sharp FO-5900 operation manual 104

Optional Settings

Setting 20: ANTI-JUNK FAX

Press 1	to block reception from fax numbers entered in the Anti Junk Fax
List. Press	2 to allow reception from all numbers.

♦Initial setting: 2

Setting 21: ALARM VOLUME

This sets the volume of the beep sound that alerts you to error conditions and

informs you that operations have been completed. Press 1 for HIGH, 2 for LOW, or 3 for OFF.

♦Initial setting: 2

Setting 22: DIAL MODE

This sets the dial mode. Press 1 if you are on a touch-tone line, or 2 if you are on a pulse dial (rotary) line.

♦Initial setting: 1

Note: For all units installed in New Zealand, select "1" for tone dialling. The pulse setting "2" will not operate correctly and must not be used.

Setting 23: QUICK ON-LINE

When you transmit a multi-page document, this setting determines whether the fax machine will dial the receiving party and begin transmitting while scanning is still in progress, or wait until all pages have been scanned before

dialling. Press 1 to have the fax machine dial and begin transmission while

scanning is still in progress, or 2 to have the fax machine wait until all pages have been scanned.

♦Initial setting: 1

Setting 24: MULTI TTI

If you are using Department Control, you can press 1 to have the

department name (the name associated with the department code entered by an operator to access the fax) appear at the top of each transmitted document. This will appear in place of the name entered in Entering Your

Name and Fax Number in Chapter 1. Press 2 to turn Multi TTI off (the

sender’s name entered in Chapter 1 will appear).

♦Initial setting: 2

104