Sharp MX-M450N Procedure for F-CODE Polling, Checking and clearing document data in a memory box

F-CODE POLLING MEMORY

Checking and clearing document data in a memory box

The procedure for checking document data in an F-code polling memory box by printing it and the procedure for clearing data from a box are almost the same as the procedures for printing and clearing document data from the Public Box.

Instead of touching the [PUBLIC BOX] key in step 3 of "Printing document data in the Public Box" or "Deleting document data from the Public Box" on page 3-16,touch the key of the desired memory box.

If a document icon ( ) appears to the right of a memory box key, document data has been stored in that box and you can print it out.

However, the contents cannot be printed or deleted while the memory box is being used for transmission.

DATACA

MARKETING GROUP

SHARP BRANCH EX

PUBLI

PROCEDURE FOR F-CODE POLLING

Make sure that a document has not been loaded in the auto document feeder or on the document glass, and then follow the steps below.

NOTES
You must know the sub-address (SEP) and passcode (PWD) of the other machine's F-code polling memory box.			4
Serial polling (selecting multiple fax machines to be polled using a group key or by touching the [NEXT
ADDRESS] key) is not possible with F-code polling.
1 In fax mode, touch the [SPECIAL MODES]		3 Enter the fax number, sub-address, and
key and then the	key.	passcode of the other fax machine.

ODE SWITCH

ADDRESS REVIEW

If the address book screen appears, touch

To use a one-touch key, SPE touch the [ADDRESS

SPECIAL MODES

UB ADDRESS

the [CONDITION SETTINGS] key to

CORPO.TPS

BOOK] key to display the address book.

FILE

TO RECEPTION

MEMORY:100% QUICK FILE

display the condition settings screen (page 1- 5).

SHARP GROUP

Refer to steps 2 through 5 on page 4-3 for the procedure for entering

sub-addresses and passcodes.

2 Touch the [POLLING] key and then touch the [OK] key.

The [POLLING] key is

POLLING RESEND highlighted and the

SPEAKER

polling icon appears.

OK	To cancel polling, touch
	the [POLLING] key once

POLLING	again to cancel the
	selection.
You will return to the initial screen.

4 Press the [START] key.

"POLLING." appears on the screen.

After communicating with the other machine, your machine prints the

received document data.

NOTES

Cancelling a transmission

Press the [JOB STATUS] and cancel the transmission in the same way as when cancelling a stored transmission. (See "CANCELLING A FAX TRANSMISSION" on page 2-9)

Only one F-code polling timer operation can be stored (see page 3-6).

4-5