Sharp MX-M450N, MX-M350N, MX-M450U, MX-M350U Setting for F-CODE Polling Memory Boxes Polling Times

PROGRAMMING, EDITING, AND DELETING F-CODE MEMORY BOXES

8 Use the numeric keys to enter a passcode (max. 20 digits).

F-CODE MEMORY BOX / POLLING MEMORY		NEXT	EXIT
	No.001
SUB ADDRESS / PASS CODE		CANCEL	OK

ENTER THE SUB ADDRESS / PASS CODE VIA THE 10-KEY PAD,THEN PRESS [OK].

214341434/351212

PASS CODE

In addition to numbers, the characters " " and "#" can be used in a passcode.

If you make a mistake, press the [C] key to clear the mistake.

9 Touch the [OK] key.

				You will return to the
				memory box programming
	CANCEL		OK
				screen. The entered sub-
-KEY PAD,THEN PRESS [OK].
				address and passcode are
				displayed.
				"REGISTRATION	IS
		PASS CODE
				COMPLETED."	appears

to the right of the box number. (Only for F-Code polling memory.)

Continue programming the settings that are particular to each type of memory box. Go to the appropriate page below:

F-code polling memory (Polling times: this page)

F-code confidential transmission (Print PIN: following page)

F-code relay broadcast transmission (Recipient: page 6-13)

SETTING FOR F-CODE POLLING MEMORY BOXES (POLLING TIMES)

You can select whether to have document data that was scanned into an F-code polling memory box automatically cleared after one transmission, or to leave the document data in the box and allow an unlimited number of transmissions when polled. (The initial setting is "ONCE". Change the setting as needed.)

1 Touch the [POLLING MEMORY] key in step

3of "PROGRAMMING AN F-CODE MEMORY BOX" on the previous page and store a box name, sub-address, and passcode.

2 Touch the [POLLING TIMES] key.

	BOX NAME	FAX INFORMATION
	SUB ADDRESS	214341434/351212
POLLING TIMES		ONCE

4 Touch the [OK] key.

You will return to the screen of step 2 and the selected polling times will appear.

5 To exit, touch the [EXIT] key.
To program another memory box, touch
the [NEXT] key.
NEXT	EXIT	Touching the [EXIT] key

returns you to the screen of step 3 on page 6-10.

Touching the [NEXT] key returns you to the screen for programming a new memory box (the

screen of step 4 on page 6-10).

6

3 Touchtimes. the key for the desired polling

If you do not wish to erase the document after polling takes place, touch the [UNLIMITED] key so that it is highlighted.

F-CODE MEMORY BOX / POLLING MEMORYNEXT EXIT

No.001

POLLING TIMES		OK
	ONCE
	UNLIMITED

6-11