Sharp FO-475TH, UX-258TH manual No. = X 60 sec = 5 min Recall times Binary input

											UX-258TH
											FO-475TH
SW	DATA	ITEM			Switch setting and function					Initial	Remarks
NO.	NO.			1					0	setting
	1	Auto gain control (MODEM)	Enable						Disable	1
	2	End Buzzer	Yes						No	1
	3	Disconnect the line when DIS is received in	No						Yes	1
SW		RX mode
l	4	Equalizer freeze control (MODEM)	On						Off	0
A6	5	Equalizer freeze control 7200 BPS only	No						Yes	0
	6	CNG transmission in manual TX mode	Yes						No	1
	7	Initial compression scheme for sharp fax in	MR mode						H2 mode	0
		TX mode
	8	Reserved								0
	1	Recall interval		Binary input						0	OPTION
	2		No. =	8	4	2	1			1
SW	3			1	2	3	4			0
	4			0	1	0	1 (5 x 60 sec = 5 min)			1
l
	5	Recall times		Binary input						0	OPTION
B1
	6		No. =	8	4	2	1			0
	7			5	6	7	8			1
	8			0	0	1	0 (Twice)			0
	1	Dial pausing (sec/pause)	4 sec						2 sec	0
	2	Reserved								0
	3	Reserved								0
SW
	4	Busy tone detection (after auto dial)	No						Yes	1
l	5	Waiting time after dialing	90 sec						45 sec	0
B2
	6	Reserved								0
	7	Reserved								0
	8	Reserved								0
	1	Reserved								0
	2	Reserved								0
	3	Reserved								0
SW
	4	Reserved								0
l
	5	Reserved								0
B3
	6	Reserved								0
	7	Reserved								0
	8	Hold function	Enable						Disable	1
	1	Auto Dial Mode Delay timer of before line	3 sec						0 sec	1
		connect
	2	Auto Dial Mode Delay timer of after line	3.6 sec						3 sec	0
		connect
SW
	3	Dial mode	Tone						Pulse	1	OPTION
l
	4	Pulse → Tone change function by key	Enable						Disable	1
B4
	5	Dial pulse make/break ratio (%)	40/60						33/67	1
	6	Reserved								0
	7	Reserved								0
	8	Reserved								0
	1	DTMF signal transmission level (Low)		Binary input						0
	2		No. =	16	8	4	2	1		1
SW	3			1	2	3	4	5		0
	4			0	1	0	1 0 (0.5 x 12 = -6 dBm)			1
l
	5									0
B5
	6	Reserved								0
	7	Reserved								0
	8	Reserved								0

2 – 6