Sharp FO-475TH, UX-258TH manual Entry data receive, Flash memory check, Flash memory clear

3. 12. Entry data receive

In this mode, the registered data sent from the other machine are re- ceived and the received data are registered in the own machine. When this mode is used for receiving, the other machine must be in the entry data send mode.

After receiving is completed, the following lists are printed.

1.Telephone list data

2.Sender register data (The passcode No. is also printed if the poling function is provided.)

3.Optional setting list

4.Soft switch content

5.Junk fax number list

6.Timer reservation list (only model which timer communication is possible)

7.Recording setting list data

UX-258TH

FO-475TH

3. 13. Flash memory check

Data writing/read of flash memory is checked, and the result (OK/NG) is printed.

3. 14. Flash memory clear

All data of flash memory is cleared.

The result of clear (OK/NG) is printed.

4. How to make soft switch setting

To enter the soft switch mode, make the following key entries in sequence.

Press FUNCTION 9

8

7

START

START

DATA No. 1 2 3 4 5 6 7 8

S F T SW-A1 = 0 0 0 0 0 0 0 0

S F T SW-A1 = 1 0 0 0 0 0 0 0

S F T SW-A1 = 1 0 0 0 0 0 0 0

S F T SW-A1 = 1 0 0 0 0 0 0 0

S F T SW-A1 = 1 0 0 0 0 0 0 0

S F T SW-A2 = 0 0 0 0 0 0 0 0

S F T SW-L2 = 0 0 0 0 0 0 0 0

Press FUNCTION key.

Press key.

Press key.

Bit1 - 8 are set.

Press START key during setting.

Soft SW-A2 - SW-L2 are set.

To finish the settings halfway between SW-A1 and SW-L2, press the STOP key. In this case, the setting being done to the SW No. on display will be nullified while settings done to the preceding SW Nos. remain in effect.

When the COPY key is pressed, the contents of soft switches are printed.

The soft switch mode is terminated.

2 – 4