7. Use of Document Carrier Sheet
A document carrier sheet must be used for the following documents.
•Those with tears.
•Those smaller than size 140 mm (W) x 140 mm (L).
•
Make print straight across paper E.G.
Place the document carrier in the document feeder with the clear film side down
Direction of insertion
NOTE: To transmit a
•Those containing an easily separable writing substance (e.g., trac- ing paper written on with a soft, heavy lead pencil).
NOTES: • When using the document carrier, carefully read the in- structions written on the back.
•If the document carrier is dirty, clean it with a soft, moist cloth, and then dry it before using for transmission.
•Do not place more than one document in the carrier at a time.
[4]Installation
1. Site selection
Take the following points into consideration when selecting a site for this model.
ENVIRONMENT
•The machine must be installed on a level surface.
•Keep the machine away from air conditioners, heaters, direct sun- light, and dust.
•Provide easy access to the front, back, and sides of the machine. In particular, keep the area in front of the machine clear, or the original document may jam as it comes out after scanning.
•The temperature should be between 5° and 35°C.
•The humidity should be between 30% and 85% (without conden- sation).
ELECTRICITY
Caution!
•Connection to a power source other than that specified will cause damage to the equipment and is not covered under the warranty.
•If your area experiences a high incidence of lightning or power surges, we recommend that you install a surge protector for the power and telephone lines. Surge protectors can be purchased at most telephone specialty stores.
If the machine is moved from a cold to a warm place...
If the machine is moved from a cold to a warm place, it is possible that the reading glass may fog up, preventing proper scanning of documents for transmission. To remove the fog, turn on the power and wait approxi- mately 2 hours before using the machine.
TELEPHONE JACK
A standard telephone jack must be located near the machine.
This is the telephone jack commonly used in most homes and offices.
•Plugging the fax machine into a jack which is not an jack may result in damage to the machine or your telephone system. If you do not know what kind of jack you have, or needed to have one installed, contact the telephone company.
2. Connections
1Connect the handset as shown and place it on the handset rest.
♦Make sure the handset cord goes into the unmarked jack on the side of the machine!
♦Use the handset to make ordinary phone calls, or to transmit and receive documents manually.
2Plug the power cord into a
♦Caution: Do not plug the power cord into any other kind of outlet. This will damage the machine and is not covered under the warranty.
Note: The shape of the plug is different in certain countries.
♦The machine does not have a power on/off switch, so the power is turned on and off by simply plugging or unplugging the power cord.
Note: If your area experiences a high incidence of lightning or power surges, we recommend that you install surge protectors for the power and telephone lines. Surge protectors can be purchased from your dealer or at most telephone specialty stores.
3Insert one end of the telephone line cord into the "TEL. LINE" jack. Insert the other end into a standard (RJ11C)
♦Be sure to insert the telephone line cord into the "TEL. LINE" jack. Do not insert into the "TEL. SET" jack.
TEL
SET. TEL
LINE.
1 – 4
