Important safety information | Sharp UX-P400 manual

Important safety information

Do not disassemble this machine or attempt any procedures not described in this manual. Refer all servicing to qualified service personnel.

Do not install or use the machine near water, or when you are wet. For example, do not use the machine near a bath tub, wash bowl, kitchen sink or laundry tub, in a wet basement, or near a swimming pool. Take care not to spill any liquids on the machine.

Unplug the machine from the telephone socket and then the power outlet and consult a qualified service representative if any of the following situations occur:

-Liquid has been spilled into the machine or the machine has been exposed to rain or water.

-The machine produces odors, smoke, or unusual noises.

-The power cord is frayed or damaged.

-The machine has been dropped or the housing damaged.

Do not allow anything to rest on the power cord, and do not install the machine where people may walk on the power cord.

This machine must only be connected to a 220 - 230 V, 50 Hz, earthed (2-prong) outlet. Connecting it to any other kind of outlet will damage the machine and invalidate the warranty.

Never insert objects of any kind into slots or openings on the machine. This could create a risk of fire or electric shock. If an object falls into the machine that you cannot remove, unplug the machine and consult a qualified service representative.

Do not place this machine on an unstable cart, stand or table. The machine could be seriously damaged if it falls.

Never install telephone wiring during a lightning storm.

Never install telephone sockets in wet locations unless the socket is specifically designed for wet locations.

Never touch bare telephone wires or terminals unless the telephone line has been disconnected at the network interface.

Use caution when installing or modifying telephone lines.

Avoid using a telephone (other than a cordless type) during an electrical storm. There may be a remote risk of electric shock from lightning.

Do not use a telephone to report a gas leak in the vicinity of the leak.

The power outlet must be installed near the equipment and must be easily accessible.

3

Image 5

Sharp UX-P400 operation manual Important safety information

Contents

UX-P400/NX-P500 Aviso Display Introduction Intended use Important safety information Table of Contents Answering Machine Connection Look at the Operation Panel START/MEMORY key COPY/HELP/POLL keyFunction key Key Unpacking Checklist InstallationPoints to keep in mind when setting up About condensation Connections Connecting the handsetConnecting the power cord Connecting the telephone line cord Other devices Attach the paper tray and paper tray extensionGermany Switzerland, Austria Loading the Imaging Film Insert the green gears Remove the new roll of imaging film from its packagingInsert the film into the print Compartment Insert the stack of paper into the tray, Print Side Down Loading Printing Paper Print contrast setting Press Funktion once Twice Entering Your Name and Fax Number Press Stop to return to the date and time display Enter a two-digit number for the day 01 to Example the 5th Setting the Date and TimePress once and once To start the clock Enter the year four digitsExample 2001 Setting the reception mode Setting the Reception ModeTEL/FAX mode Mode Shows the desired volume level Volume AdjustmentSpeaker Press Until the display If you selected Ringer OFF OK ? Ringer Flash Select Setting for PBX Press Funktion once Once Setting the Display Language Transmittable Documents Size and weightSending Faxes Other restrictions Loading the Document Resolution settings Adjusting the Resolution and Contrast One or more times until Contrast settingsLoad the documents Sending a Fax by Normal Dialling When transmission is completed, the fax will beep once Press Funktion once Sending a Fax by Automatic DiallingStoring fax and phone numbers for automatic dialling Press Speicher Make the desired changes to the name Editing and clearing auto-dial numbersSelect Edit or Clear Return to to edit or clear another number, or press Stop to Using an auto-dial numberReturn to the date and time display If you are sending a fax, load the documents Sending a fax by Direct Keypad Dialling Automatic redialling Redial Empfang to set Sending a Fax From MemoryBroadcasting sending a fax to multiple destinations If the memory becomes full Memory transmission Pseudo Ring Duration for Tel/Fax Mode Using TEL/FAX ModeReceiving Faxes Empfang until the arrow Enter a number as follows for the desired duration Using A.M. ModePress once and 3 times Press Funktion once and once Using FAX ModeChanging the number of rings Number from 2 to Using TEL ModeEnter the desired number of rings any Replace the handset Answering with the fax’s handset Phone goes dead Fax Signal Receive Optional Reception Settings Press To turn on the function, or Changing the number for remote fax activationTo turn it off Enter the desired number any number from 0 to Example 3 Select 100% Reception RatioPress To select AUTO, or 2 to Substitute Reception to Memory Load the documents face down. Maximum of 10 pages Making Copies Copy Cut-off Preparations Answering Machine ConnectionChanging the outgoing message Comments Set your answering machine to auto answer Using the Answering Machine ConnectionSet the reception mode to A.M Quiet Detect Time Optional A.M. Mode SettingsHow answering machine mode operates Quiet Time On A.M. Failure Quiet Start Quiet Detect Start Time Special Functions Caller ID Requires Subscription to ServicePress YES to turn on Caller ID To turn off Caller ID, press Display messages How Caller ID operates Viewing the Caller ID list Press Stop when you have finished viewing the listPress Twice Dialling and transmission begin Fax Press Speicher to store or clear the number To delete calls from the Caller ID listPriority Call Blocking voice calls Press once and twice Blocking Reception of Unwanted FaxesPress Funktion once and twice Press Abruf Polling Requesting a Fax Transmission Transferring calls PBX operationsMaking enquiry calls Printing Lists Setup ListTelephone Number List Caller-ID List Headings in Transaction Report Transaction Report Help List Transaction Report print condition Print head Maintenance Scanning glass and rollers Maintenance If the scanning glass is difficult to clean Housing Problems and Solutions TroubleshootingLine error Problem Solution Correct socket. See Connecting the handset on Dialling and transmission problems Reception and copying problems Answering machine connection See Loading the Imaging Film on General problems Press Start KEY Messages and Signals Substitute Reception to Memory on page 48. If you Recalling Audible signals Clearing a jammed document Clearing Paper Jams Clearing jammed printing paper Sending Faxes Quick Reference Guide Index Index Page Sharp Electronics Europe Gmbh