Sharp UX-S10 manual Comments

Remote Operations

4 When you have finished listening to your messages, you can do any of the following:

•	Erase all messages: Press	3 ,	3 , and	.
•	Repeat playback: Press 7	and	.

•Perform other operations: You can enter any of the commands described in the following section, Other remote operations.

•Hang up: If you do not erase your messages first, they will be saved and any new messages will be recorded after them. If you want the machine to

resume normal operation immediately, press twice before hanging up (in some cases, particularly when the Transfer function is used, the machine may not accept new calls for one or two minutes after you hang up

unless you press twice).

Note: You can also call the machine and perform remote operations when the reception mode is set to FAX. In this case, when you call the machine, press

immediately after it answers (before you hear the fax tone), and then continue from Step 2 above.

Comments:

♦When a remote command is accepted by the machine, you will hear one beep. If an incorrect command is entered, you will hear four beeps. In the latter case, re-enter the correct command.

♦When entering a command, do not pause longer than 10 seconds between each digit. If you do, you will hear a 4-beep error signal and the digits entered up to that point will be cleared. In this case, re-enter the command from the beginning.

♦If you pause for longer than 10 seconds before entering a command, or make two errors while entering your remote code number, the line will be disconnected. (This prevents unauthorized people from attempting to guess your remote code number.)

56