Preparation

Preparation

13

Inserting and Removing a Card

You can use an SD Memory Card or a MultiMediaCard for storing still images.

Inserting

1 Make sure that the Power switch is set to OFF.

2 Slide the card slot cover release and open the card slot cover in the direction of the arrow.

Card slot cover release

3 Insert a card into the slot as shown below, and push it in as far as it will go.

Write-protect switch

Label

Clipped corner

4 Close the card slot cover.

Removing

Perform steps 1 and 2 above, push the card

(1) and pull the card straight out (2) as shown below.

Notes:

You can use only the SD Memory Card or the MultiMediaCard (see page 71).

The supplied card is preformatted for immediate use.

See pages 73 and 74 for more information on the cards intended for use with this camcorder.

Caution:

Do not remove the card from the camcorder while recording data on the card (Sindicator flashes during recording). This may delete the recorded image or damage the card.

About the write-protect switch

SD Memory Card has a write-protect switch. When the switch is set to the locked position, you cannot record/delete data or format the card. Set it to the unlocked position to record/ delete data or format the card.

Back view

Unlocked position

Locked position

VL-NZ100H-009-018

13

02.2.14, 9:58 AM

Page 24
Image 24
Sharp VL-NZ100S manual Inserting and Removing a Card, About the write-protect switch, Close the card slot cover