Installing the Lithium Battery

Installing

The supplied lithium battery is used to store the memory of the date and time settings.

Removing

Perform steps 1 and 2 above, then lift out the battery from the battery holder.

1 Slide the cassette compartment door release and open the cassette compart- ment door.

Note:

The cassette holder will extend and open when the camcorder is connected to a power source. Be sure to close the cassette holder before proceeding to the next step (see page 12).

2 Pull out the lithium battery holder using a pointed object such as the tip of a ballpoint pen.

Notes on the Use of the Lithium battery

CAUTION: Danger of explosion if battery is incorrectly replaced. Replace only with the same or equivalent type CR2025 recom- mended by the equipment manufacturer.

XKEEP THIS BATTERY AWAY

FROM CHILDREN. IF SWALLOWED,

CONSULT A PHYSICIAN IMMEDIATELY FOR

EMERGENCY TREATMENT.

ZBATTERY MAY EXPLODE IF

MIS-USED OR INSTALLED WITH POLARITY

REVERSED. DO NOT RECHARGE, DISAS-

SEMBLE OR DISPOSE OF IN FIRE.

Preparation

3 Insert the lithium battery into the battery holder with the Hside of the battery facing the

mside of the holder.

Lithium battery

holder

m” mark

• Do not short-circuit, recharge, disassemble, or

heat the lithium battery.

• Should the lithium battery leak, wipe the battery

compartment clean, and then insert a new

battery.

• The lithium battery will last about one year under

normal usage.

4 Push the battery holder back into position. Press the Wmark gently, then close the cassette compartment door by pressing the centre until it clicks into place.

14

VL-NZ100H-009-018

14

02.2.14, 9:58 AM

Page 25
Image 25
Sharp VL-NZ100S manual Installing the Lithium Battery