Using the Camcorder as a Converter

Available mode:

TAPE-VCR

You can use this camcorder to convert from analog signal (e.g. video recorded on 8 mm or Hi8 tapes) to digital signal.

Connect the audio/video cable and DV cable as shown below.

To DV terminal

Recording

(digital equipment)

 

e.g. computer

DV cable (commercially available)

Digital signal

To DV terminal

To AV jack

Analog signal

Audio/video cable (supplied)

Yellow: To video output jack

White: To audio output (L) jack

Red: To audio output (R) jack

Playback

(analog equipment)

e.g. 8 mm or Hi8

camcorder

: The arrow shows the signal flow.

Note:

See page 2 for how to open the jack cover.

1 Set the camcorder to TAPE-VCR mode, and make sure that playback stops.

2 Press the MENU button to display the menu screen.

3 Press l or m on the operation button to select V, then press the SET button.

4 Press l or m to select “ANLGnDGTL”, then press the SET button.

P L A Y B A C K S E T

P I C . E F F E C T

A U D I O D U B

A U D I O

A N L GD G T L O F F

R E T U RN O N

5 Press l or m to select “ON”, then press the SET button.

A N L GD G T L O N

6 Press the MENU button to turn off the menu screen.

7 Press the Play button on the analog equipment

Check the monitor on the digital equipment to see if the picture is being properly received.

8 Press the Record button on the digital equipment.

Notes:

The camcorder is not guaranteed to work with all digital/analog equipment. Contact the manufac- turer of your equipment for advice.

If the camcorder outputs a video recording with a copyright signal, the digital equipment cannot record or save it.

The camcorder may not convert some input video recordings properly (e.g. discolouration, picture noise, muted sound), depending on the input condition.

Advanced Features

50

VL-NZ100H-047-054

50

02.2.14, 10:02 AM

Page 61
Image 61
Sharp VL-NZ100S manual Using the Camcorder as a Converter, L G D G T L O N, To DV terminal, Digital equipment