Sharp VL-NZ100S manual Tape Playback, Using Earphones Commercially Available, To stop playback

Basic Operations

Playback

Tape Playback To stop playback

Basic Operations

Available mode:

TAPE-VCR

The LCD monitor screen functions as a handy playback monitor. Nothing needs to be connected, allowing instant on-screen play- back with the sound through the built-in speaker.

Media Selection switch

Power switch

Operation button

1 Set the Media Selection switch to TAPE.

2 Hold down the Lock button and set the Power switch to VCR.

Lock button

3 Press j (or k) on the Operation button to rewind (or fast forward) the tape to the desired point.

4 Press m to begin playback.

Press l.

To turn the power off

Set the Power switch to OFF without pressing the Lock button.

Note:

•The tape is automatically rewound when playback reaches the end of the tape.

Using Earphones (Commercially Available)

Available modes:

TAPE-VCR, TAPE-CAMERA

You can monitor the sound via stereo ear- phones (commercially available) during playback or recording. Stereo earphones with a

3.5mm diameter plug can be used with this camcorder.

Connect the plug of stereo earphones to the PHONES jack on the camcorder as shown below.

Note:

•If you press the REC START/STOP button in

TAPE-VCR mode, the “ ” mark appears and the camcorder enters Recording Standby mode.

If you do not intend to record, press l to turn

the “ ” mark off, then press m to begin playback. This will ensure your previous recording is not erased (see pages 49, 51).

23

PHONES jack

Notes:

•Before connecting stereo earphones, turn the camcorder volume down to the lowest setting.

•The built-in speaker automatically turns off when stereo earphones are connected to the PHONES jack.

VL-NZ100H-019-025 23 02.2.14, 9:59 AM