Basic Operations

Playback

Watching Playback on a

Caution:

TV

• Check that the camcorder, TV, VCR and

other equipment to be used are turned off

 

before making any connections. Picture

Available modes:

noise or malfunction may occur if any of the

TAPE-VCR, CARD-VCR

above is left on while making a connection.

Basic Operations

You can connect the camcorder to a TV to allow a larger audience to enjoy playback.

1 Open the jack cover on the camcorder (see page 2).

Jack cover

2 Connect the camcorder to your TV (or VCR) with the supplied audio/video cable, as shown.

Yellow: To video input jack

White: To audio input (L) jack

Red: To audio input (R) jack

Audio/video cable (supplied)

3 Turn on the TV and set it to the “AV” or “VIDEO” channel. (See the operation manual of your TV.)

When connecting to a TV via a VCR, turn on the VCR and set it to the “AV” or “LINE” input channel. Operate the TV as you normally do to view the signal from the VCR. (See the operation manuals of your TV and VCR.)

4 Set the Power switch on the camcorder to VCR, and begin playback (see page 23).

Notes:

If your TV or VCR has a 21-pin Euro-SCART connector, use the RCA/21-pin Euro-SCART conversion connector (QSOCZ0033TAZZ) available from our main parts distributor detailed on page 78.

21-pin Euro-SCART on TV or VCR

0RCA/21-pin Euro-SCART conversion connector

 

 

(QSOCZ0033TAZZ)

(L/MONO)

(R)

VIDEO AUDIO

AUDIO

 

Video

Audio R

Audio L

 

If your TV or VCR has only one audio input jack, use the white plug for the audio connection on the TV or VCR.

Close the jack cover after use.

To AV jack

: The arrow shows the signal flow.

25

VL-NZ100H-019-025

25

02.2.14, 9:59 AM

Page 36
Image 36
Sharp VL-NZ100S manual Watching Playback on a, Basic Operations Playback