2 Remove the lens cap.
3 Set the Media Selection switch to CARD.
4 Hold down the Lock button and set the Power switch to CAMERA.
• The picture from the lens now displays. Number of shots taken/remaining
CARD
9 / 8 1
NORMAL
Insert a card into the camcorder (see page 13).
1
Camera Recording
Card Recording
Available mode:
CARD-CAMERA
You can take a still picture in the same way as you do with a standard camera and record that image on the card.
STILL button
Power Zoom control
Media Selection switch
Power switch
Digital Still Camera Features

StillDigitalCamera Features

Lock button

A U T O

55

VL-NZ100H-055-058

55

5 Adjust the Power Zoom control to frame the subject as you desire.

6 Press the STILL button half-way down to focus on the subject.

The camcorder automatically focuses on the subject. When it is set, you will hear a sound and see T mark, then the camcorder locks the focus.

CARD

9 / 8 1

NORMA L

7 Press the STILL button fully to begin recording.

CARD

9 / 8 1

NORMAL

A U T O

The S indicator flashes red while data is being recorded on the card, and returns to white when recording completes.

To record another image, release the STILL button and make sure the picture is not frozen in the monitor, then perform steps 6 and 7.

Notes:

Recording under insufficient lighting may result in blurred images. It is recommended that you use a tripod to record insufficiently illuminated subjects.

Recording under the light of a fluorescent, mercury, or sodium lamp may cause flickering in the image and, depending on the timing of the shot, may result in changes to colour hue in the image.

Set the BEEP menu item to “OFF” to turn off the focus locking sound.

Caution:

Do not turn the power off while the S indicator is flashing in step 7.

02.2.14, 10:03 AM

Page 66
Image 66
Sharp VL-NZ100S manual Press the Still button fully to begin recording, Lock button