Sharp VL-NZ100S manual Card

Appendix

Appendix

	Symptom	Possible cause	Suggested solution
	Cannot rewind or fast for-	Position at beginning or end of tape.	Rewind or fast forward tape to de-
mode	ward tape.		sired point (p. 23).
	Video noise in image.	Dirty video heads.	Call for service (p. 78) or use a com-
VCR
			(p. V).
			mercially available cleaning tape
mode		Old or worn tape.	Use a new cassette.
	Cannot delete image on	Image is delete-protected.	Cancel the protection setting (p. 60).
CARD	card.
	Cannot format card.	——	Contact your dealer for advise.
	Cassette will not eject.	Power source is not properly con-	Connect power source properly
		nected.	(pp. 9, 11).
		Battery pack is not charged.	Charge battery pack sufficiently
			(p. 10).
		Camcorder is recording.	Stop tape and try again (p. 20).
	No image on monitor.	Backlight has been turned off.	Turn on backlight (p. 68).
		Fluorescent lamp has burned out.	Call for service (p. 78).
	Monitor picture is hard to	Inappropriate picture adjustments.	Adjust picture (p. 68).
	see.
General	Charge indicator flashes	AC adapter or battery pack may have	Call for service (p. 78).
	in red when charging	malfunctioned.
	battery pack.
	Cannot edit to connected	Audio/video cable is not properly	Connect audio/video cable properly
	VCR.	connected.	(p. 48).
	Remote control does not	REMOTE menu item is set to “OFF”.	Set REMOTE menu item to “ON”
	function.		(p. 38).
		Remote control battery has run down.	Replace remote control battery with
			new one (p. 38).
		Remote control used beyond operat-	Use remote control within operating
		ing range.	range (p. 38).
		Intense daylight falling on camcorder	Protect remote sensor from exposure
		remote sensor.	to intense daylight (p. 38).
		Obstacle between remote control and	Remove obstacle or use remote con-
		camcorder remote sensor.	trol from different angle (p. 38).

Notes:

• This unit is equipped with a microprocessor. Its performance could be adversely affected by external electrical noise or interference. If this should happen, turn off the power and disconnect the unit from any power sources, including the lithium battery, etc. Then reconnect the power sources to resume operation.

• If the characters displayed on the monitor screen appear to malfunction, disconnect the power source and remove the lithium battery, then reconnect the power source, insert the lithium battery, and turn the power on again. The characters on the monitor should be normal. Set the date and time, then resume operation.

79

VL-NZ100H-074-080 79 02.2.14, 10:05 AM