Sharp XG-P610X-N Geometric Adjustment, Basic Operation, Upper Left, Upper Right, Lower Left

Press ENTER to set the posi- tion.

Repeat the same procedure with the positions for the upper right, lower right and lower left of the image.

• At this time, pressing UNDO on the pro- jector or on the remote control returns to the previous screen.

• Before correcting the upper left of the image, pressing UNDO returns to the re- set confirmation screen.

• When the position of the lower left is set, the correction is made and the display disappears.

• If the message “Can not correct.” is dis- played, step 2 may have been performed incorrectly. In this case, go back to step 2 and try the procedure again.

5

6

GEOMETRIC ADJUSTMENT

1 Press KEYSTONE on the pro- jector or on the remote control repeatedly until “GEOMETRIC ADJUSTMENT” is displayed.

2 Press the buttons below to ad- just the position, size or focus of the projected image.

• Match screen’s four sides to green test pattern.

• Pressing ', ", \ or on the projector or H&V LENS SHIFT on the remote control allows you to shift the lens.

• Pressing ZOOM +/– on the projector or on the remote control allows you to ad- just the projected image size.

• Pressing FOCUS +/– on the projector or on the remote control allows you to adjust the focus.

3 Press ENTER on the projector or on the remote control.

4 Press ', ", \ or to move the position for the upper left of the image.

• Move the upper left of the yellow frame onto the upper left of the screen.

▼On-screen display

Geometric Adjustment

Upper Left Upper Right Lower Right

Lower Left

-33

Basic Operation