Helpful Functions Set during Installation (ÒOptions 2Ó menu)
qSelecting the Transmission Speed (RS-232C)
Make sure that both the projector and computer are set for the same baud rate.
Selectable items | Description | |
9600 bps | Transmission speed is slow. | |
|
|
|
38400 bps |
|
|
|
| |
|
|
|
115200 bps | Transmission speed is rapid. | |
|
|
|
Note
•Refer to the “SETUP MANUAL” contained on the supplied
•Refer to the computer’s operation manual for instructions for setting the computer’s baud rate.
wSetting the Monitor Output
When the Monitor Out has been set to ÒEnableÓ, the monitor output is activated and power is con- sumed even in the standby mode. It is recom- mended that the Monitor Out be set to ÒDisableÓ when it is not connected. This reduces power consumption when the projector is in the standby mode.
Selectable items | Description |
Enable | The monitor output function is activated |
| even if the projector is in standby mode. |
Disable | The monitor output function is switched off |
| when the projector is in standby mode. |
|
|
Menu operation 
Page 47
eSetting the LAN/RS232C
When the LAN/RS232C has been set to ÒEnableÓ, the LAN/RS232C is activated and power is con- sumed even in the standby mode. It is recom- mended that the LAN/RS232C be set to ÒDisableÓ when it is not connected. This reduces power consumption when the projector is in the standby mode.
Selectable items | Description |
Enable | The LAN/RS232C function is activated |
| even if the projector is in standby mode. |
Disable | The LAN/RS232C function is switched off |
| when the projector is in standby mode. |
|
|
Note
•When you want to control the projector using the LAN/RS232C function, select “Enable.”
•The item “LAN/RS232C” will be made unavail- able for setting when “Master” or “Slave” is se- lected on “Stack Setting”. (“LAN/RS232C” will be set to “Enable” automatically.) (See page 62.)
rSetting the DHCP Client
Connect the LAN cable before turning the pro- jector on. If not, the DHCP Client function does not work.
Selectable items | Description |
ON | Obtains configuration parameters for |
| TCP/IP network automatically. |
OFF | Sets the TCP/IP manually. |
Note
•Select “ON” for “DHCP Client”. “Obtaining IP Address...” appears, then the message “The network settings have been changed.”, IP Address, Subnet Mask and Gateway will be displayed.
•If the DHCP server is not available, “Could not obtain IP Address.” appears.
In this case, set the TCP/IP manually. (See “Set- ting the TCP/IP” on page 65.)
-64
