Sharp XG-P610X-N quick start Troubleshooting

Troubleshooting

Problem	Check	Page
An unusual sound is	• If the picture is normal, the sound is due to cabinet shrinkage	—
occasionally heard	caused by room temperature changes. This will not affect
from the cabinet.	operation or performance.
Maintenance	• See “Maintenance Indicators”.	69
indicator illuminates or
blinks in red.
The projector cannot be	• If the “Keylock Level” menu is set to “Level A” or “Level B”, all or	63
turned on or put into the	specific buttons on the projector are unavailable. Use the
standby mode using the	remote control to operate the projector.
ON or STANDBY button
on the projector.
All buttons on the	• If the “Stack Setting” menu is set to “Slave” and the “Keylock	17
projector and the remote	Level” menu is set to “Level B”, all buttons on the projector and	62
control are unavailable.	the remote control are unavailable. Connect the remote control	63
	to the projector, and then use the remote control to operate the
	projector.
Picture is green on	• Change the input signal type setting.	51
COMPUTER 1or 2
(COMPONENT).
Picture is pink (no green)
on COMPUTER 1/ 2 or
DVI (RGB).
The black levels of the	• Make adjustments that result in the best picture quality in the	51
image show banding or	“Dynamic Range” setting.
appear faded when DVI
or HDMI is selected.
Picture is too bright and	• Image adjustments are incorrectly set.	49
whitish.
The cooling fan	• When temperature inside the projector increases, the cooling	9, 10
becomes noisy.	fan runs faster.	66, 69, 70
The lamp does not light	• The lamp indicator is illuminating in red.	69
up even after the	Replace the lamp.
projector turns on.
The lamp suddenly turns
off during projection.
The image sometimes	• Cables are incorrectly connected to the projector or the	24–27
flickers.	connected equipment works improperly.
	• If this happens frequently, replace the lamp.	72
The lamps take a long	• The lamps will eventually need to be changed.	72
time to turn on.	The lamps have reached the end of its life. Replace the lamps.
Picture is dark.
The remote control	• Operate the remote control while pointing it at the projector’s	16
cannot be used.	remote control sensor.
	• The remote control may be too far away from the projector.
	• If direct sunlight or a strong fluorescent light is shining on the
	projector’s remote control sensor, place the projector where it
	will not be affected by strong light.
	• Is a ø3.5 mm minijack cable plugged into the WIRED REMOTE
	terminal?
	• The batteries may be depleted or inserted incorrectly. Make	16
	sure the batteries are inserted correctly or insert new ones.

This projector is equipped with a microprocessor. Its performance could be adversely affected by incorrect op- eration or interference. If this should happen, unplug the projector and plug it in again after more than 5 minutes.

-80