Sharp XG-P610X Turning the Projector On/Off, Connecting the Power Cord, Turning the Power Off Put

Turning the Projector On/Off

Connecting the Power Cord

Plug the supplied power cord into the AC socket on the rear of the projector. Then plug into the AC outlet.

Turning the Projector On

Before performing the steps in this section, connect any equipment that you use with the projector. (See pages 24–27.)

Remove the lens cap and press ON on the projector or on the remote control.

•The power indicator illuminates green.

•After the lamp indicator illuminates, the projec- tor is ready to start operation.

•When System Lock is set, the keycode input screen appears. Enter the right keycode to start projection. See page 60 for details.

Note

•The lamp indicator illuminates or blinks, in- dicating the status of the lamp.

Green: The lamp is on.

Blinking green: The lamp is warming up.

Red: The lamp is shut down abnormally or the lamp should be replaced.

•When switching on the projector, a slight flick- ering of the image may be experienced within the first minute after the lamp has been illumi- nated. This is normal operation as the lamp’s control circuitry is stabilizing the lamp output characteristics. This does not indicate malfunc- tion.

•If the projector is put into standby mode and immediately turned on again, the lamp may take some time to illuminate.

Supplied Power cord accessory

Rear view

To AC socket

To AC outlet

Power cord

Info

•When “Auto Restart” is set to “On”:

If the power cord is unplugged from the AC outlet or the breaker switch is turned off when the projector is on, then the projector automatically turns on when the power cord is plugged into the AC outlet or the breaker switch is turned on. (See page 63.)

•English is the factory preset language. If you want to change the on-screen display to another language, change the lan- guage according to the procedure on page 65.

STANDBY button

ON button

ON button

STANDBY

button

		Power indicator
Lens cap	Lamp indicators1, 2

Turning the Power Off (Put-

ting the Projector into Standby Mode)

Press STANDBY on the projector or on the remote control, then press that but- ton again while the confirmation mes- sage is displayed, to put the projector into standby mode.

▼On-screen display

Info

•You can unplug the power cord from the AC outlet even if the cooling fan is still running. Even if you unplug the power cord from the projector, the cooling fan continues to run for a while.

-28