Charge and call duration display
Step
by
step
Charge and call duration display
Call charge display
You can use call charge display if you have registered for this with your provider.
The units/total charges accumulated and the cost of the last call completed can (depending on programming) be checked using your Comfort handset. The to- tal cost includes the charges incurred by the handset. If you do not receive tariff information from your provider the duration of the call will be displayed.
Configuring determination of costs
Check with your provider as to whether the call costs will be transmitted as tar- iff units or as amounts. You can then set the accounting method accordingly as either Units cent.off. or Costs cent.off..
If you have selectedCosts cent.off. but only units have been transmitted by the service provider, the device automatically switches to Units cent.off. when the call is completed.
Setting up Costs cent.off.
1.Press *for the selection menus.
2.Select using [ ] and [OK ]: Costs.
3.Select using [ ] and [OK ]: Type of calcul.
4.Select using [Z] and [OK ]: Costs cent.off.
If the item is marked with 'the call costs transmitted by the provider will be displayed. No further settings are needed.
Info If you have also entered a rate (see section , “Entering the price per unit”) the call costs will be multiplied by this rate. You can also use a rate if you want to bill for higher call costs, otherwise disable the rate (the cost display is to be in- creased by factor 2, for example).
Setting up Units cent.off.
1.Press *for the selection menus.
2.Select using [ ] and [OK ]: Costs.
3.Select using [ ] and [OK ]: Type of calcul.
4.Select using [Z] and [OK ]: Units cent.off.
If the item is marked, the units transmitted by the provider will be displayed or used to calculate the costs. If the default setting No rate is used, the units will be displayed.
67
