Operation using a telephone system

Step

by

Step

Activate the keypad for the next call only

All dialling characters (0-9, *, #) are sent as a keypad character sequence when the next connection is made (dialling and call). When connected, the keypad *is retained and the unit does not automatically switch to tone dialling (DTMF).

1.is pressed for menus.

2.Press [Z] and [OK ] to select: Base Settings Call preparat. Temp. keypad ('before menu item = ON / none = OFF).

Special requirements

If you encounter problems when connecting your Gigaset 4110/isdn behind your ISDN PBX, such as:

-handset does not ring to signal incoming calls, or

-a fault message is displayed

you should consider the following essential requirements:

First requirement:

Each Gigaset terminal (handset) requires a separate send MSN.

1st step

*Store 1 internal MSN of your PBX for each Gigaset terminal.

1.is pressed for menus.

2.Press [Z] and [OK ] to select: Base Settings Settings ISDN settings Set up MSN .

2nd step

Assign each Gigaset terminal one of the previously stored MSNs as the send *MSN (such as “Internal 0” to “Internal 2”).

1.is pressed for menus.

2.Press [Z] and [OK ] to select: Base Settings Settings System settings Setup user Setup device → Press [)] to open the additional menu → Send MSN.

Second requirement:

It is not possible for several MSNs of the Gigaset to be called simultaneously from your PBX.

To ensure that the registered handsets can ring at the same time when a call arrives, first make the following setting:

3rd step

Store another internal MSN of your PBX in your Gigaset 4110isdn. This internal MSN of your PBX serves as a call group address for Gigaset terminals that can *be combined in step 2.

1.is pressed for menus.

2.Press [Z] and [OK ] to select: Base Settings Settings ISDN settings Set up MSN .

84

Page 85
Image 85
Siemens 4110 operating instructions Special requirements, Activate the keypad for the next call only