Industry Automation and Drive Technologies - SCE

4.7FB1 Error Information

If an error occurs, ERROR = 1 is set.

The exact cause for the error is indicated in ERRCODE.

Error information

0000: No error

1xyz: Internal FB1error

2xyz: Evaluation device error

8xyz: Error indications of internal SFCs

Explanation

No error

Impermissible model number (parameter model). The values 1 to 15 are permissible

Impermissible reveive area. Only data type BYTE is permissible

Impermissible data area. Only data blocks are permissble

The receive area does not exist (data block not available)

The receive area is too short

The receive area is write protected

The delay value is outside the permissible range of 0 to 9.999.999us

Selected model number is not trained

Transfer of SFC14 and SFC 15 error indications

No module is configured for the specified logical base address

An access error was detected during the access to the IO

System error at the external PROFIBUS DP interface

4.8Data Block DB10

Tasks of DB10

DB10 is laid out for the structured acceptance/storage of the data from one Main ROI and a maximum of 16 Sub-ROIs. In the setup support, the number of Sub-ROIs is set in Connections – Register Output.

.

TIA Training Document

Page 29 of 47

Module

E12

 

 

Status: 01/2010

Vision Sensor Shape Check with SIMATIC S7-300F 2PN/DP and VS120

Page 29
Image 29
Siemens E12 manual Error information, Data Block DB10 Tasks of DB10