Diagnostics over Industrial Ethernet
6.1Introduction
The ELS has a configuration and diagnostic interface.
The device can be configured and its current status displayed using a graphic interface. All configuration or status data is available as MIB objects and can be modified and displayed within the graphic user interface.
The ELS has the following configuration functions:
●Configuration of the IP address, the subnet mask and the gateway using the Primary Setup Tool (PST).
●Reset of all values to the factory settings using the PST.
●Configuration of
●Configuration of individual events that will trigger the sending of
The ELS has the following diagnostic functions:
●Display of the current status of the ports (link up/down, transmission rate, and duplicity).
●Display of the MAC address, the IP address, the subnet mask, the gateway, and the type of configuration (manual or using DHCP).
●Trap and
●Display of statistical values of errors that have occurred on the network and that were detected by the ELS (CRC, defective frames, collisions etc.).
●Display of the system up time and the hardware and firmware version.
46 | Industrial Ethernet |
