User’s Guide
Enable or disable the TFTP protocol
SET IP TFTP [ENable DIsable ] (default = enable)
SET IP TImeout
Set TCP Inactivity timeout , in seconds if fast timeout is enabled, otherwise in minutes.
SET IP TImeout | n |
|
(default | = 1 | minute) |
SET IP WIndow
Set TCP maximum window size in bytes
SET IP WIndow nn (default = 10240)
SH IP
Shows TCP/IP related Parameters
sample output: |
|
|
|
|
IP is enabled |
|
|
|
|
IP address | 192.0.0.192 |
| Boot tries | 3 |
Subnet mask | 0.0.0.0 |
| Boot method | AUTO |
IP Gateway | 0.0.0.0 |
| Max window | 10240 |
(set manually) |
|
|
| |
LPD banner | disabled |
| Timeout | 1 min |
LPD retries are disabled |
| Keepalive | 5 min | |
Service |
| Port | TCP port |
|
xxxxxx_S1_A |
| S1 | 9100 |
|
xxxxxx_S1_B |
| S1 | 3001 |
|
Power Configuration Commands
SET POWER DELAY nnnn
This is the time, in milliseconds, to wait before the processor goes into power save mode. If no I/O occurs on the network or from the attached peripheral within this time period, the processor will go into low power mode. The value must be between 0 and 1800000 (30 minutes). A value of 0 disables processor power saving. The default value is 0.
SET POWER PERIOD nnnn
If radio power save is enabled, this the time, in milliseconds, between radio wake up events. The value must be between 1 and 65535. The default value is 65535.
SET POWER WINDOW nnnn
Document | 60 |
