4INSTALLATION
4.1INSTALLATION PROCEDURE
Qualified personnel must carefully observe the installation procedure to install the projector and to ensure best performances.
Note: The projector is
1.Choose the installation type and read the instructions through carefully. Determine the distance between the screen and the front of the projector.
Determine the projection angle.
2.Remove the top and front projector covers.
3.Insert the correct spacers between lenses and tubes.
4.Prepare and install the screen.
5.Install the projector on the floor or on the ceiling and center the screen, maintaining the factory deflection settings.
6.Focus carefully by adjusting the lenses.
7.If the installation type is the same as the factory setting, go to step 11, otherwise continue.
8.Tilt the red and blue tubes until the three crosses are superimposed.
9.Adjust the magnets.
10.Switch the projector off and disconnect the power cable.
11.Put the cover on the video projector.
12.Carry out a fine adjustment of the picture with the remote control RC 3000.
4.2 Removing the cover
4.2.1 Removing the top cover
Loosen the 2 securing screws (A) and lift the cover up.
A
SVP 450 PLUS - SVD 500 PLUS
To remove the top cover completely you must unscrew the two locking screws (B) close to the two pivots and the other two (C) securing the jointed rod to the cover.
C
B
4.2.2 Removing the front panel
Unscrew the two screws (D) on the left and right of the front panel. Unscrew the three screws (E) on the bottom and take the panel off. The position of the screws is shown by the arrows. To remove the front panel, press the two tongues (F), which are located in its lower portion.
D
D F E
F
E
4.3 INSTALLATION TYPES
4.3.1 Installation choice
Choose one of the following possible installation types:
•DESK TOP FRONT projection
•DESK TOP REAR projection
•CEILING FRONT projection
•CEILING REAR projection
ENGLISH
15