The setting USER ADJUSTMENT regards an optional colour temperature setting, which must be carried out by
aQUALIFIED TECHNICIAN upon installation, should the end user wish a different colour temperature than the set ones. The 3200° K colour temperature is used only when the projector is placed inside television studios. The 6500° K colour temperature is mostly used being considered the most pleasant and the one that reproduces colour most faithfully.
SVP 450 PLUS - SVD 500 PLUS
switched on.
The current conversion mode is shown by an arrow on the left. Use the arrow 
or 
to select a different conversion mode and press ENTER to confirm the selection. Press EXIT to return to the previous menu. Press ESC to exit.
Note: The progressive conversion mode is the best one for using the videoprojector with TV. The line insertion and field insertion conversion are best used in special cases (e.g. in broadcasting studios).
ENGLISH
3.17 UPC converter |
| 3.18 Storing |
|
|
|
A UPC converter is installed inside the projector which doubles the input signal lines for a better quality picture and reduces common video defects, such as space between lines and trembling.
The UPC converter, which enhances the video quality and reduces some comon problems of television video signals, uses IQTV technology, offering great video picture improvements such as stability, noise reduction and increased contrast.
Note: The UPC converter accepts standard signal (CVBS) and separate synchros (CVS) from 1 VPP to 4 VPP, (negative only).
To switch the converter on/off, use the UPC button: when pressed the first time it turns it on, the second time it switches the converter off. To change the conversion
mode, follow the procedure: press 
for at least 2 seconds, the screen displays the first menu:
VIDEO MENU
NOISE RED.
STD SELEC.
BLANKING
WHITE BALANCE
UPC MENU
TLV SYNC
To store contrast, brightness, colour peaking and hue parameters as SET values (standard).
To store contrast, brightness, colour peaking and hue parameters as USER values (personal memo).
The projector stores two different picture setting adjustments. The USER adjustment is loaded each time the switch 
is ON and the SETadjustmentwhich is loaded each time the 
button on the remote control is pressed. Both adjustments can be changed.
The SET adjustment is used when the adjustment parameters are changed and one wishes to return to the initial values.
To change peaking, colour, contrast, brightness and hue of the set adjustment.
To change the adjustment, press • • •
thus gaining access to the MAIN PARAMETERS menu. The following menu is displayed:
MAIN SETTINGS
MEMO NOR DATA
INSTALL. MENU
Press the arrow 
or 
to select UPC MENU and press ENTER to confirm, the screen displays the second menu:
UPC ON
PROGRESSIVE
LINE INSERT
FIELD INSERT
The menu operates only if the UPC converter is
Use the arrow 
or 
to select the function MEMORIZE NORMALIZED DATA. Press ENTER to confirm the stored adjustment parameters, the following message is displayed:
MAIN SETTINGS
MEMO NOR DATA
INSTALL. MENU
STORED
13
