Sim2 Multimedia SVP 420 HB, SVP 450 PLUS Projector centering, Optical and electrical adjustments

	Projections at 0°
	BLUE		GREEN		RED
0	0,5	0	0	0,5	0
	0,2			0,2
60"
	0,5	0	0	0,5
0	0,2			0,2	0
0	0,5	0	0	0,5	0
80"
0	0,5	0	0	0,5	0
0	0,3	0	0	0,3	0
100"
0	0,3	0	0	0,3	0
0	0,2	0	0	0,2	0
120"
0	0,2	0	0	0,2	0
0,2	0,3	0	0	0,3	0,2
150"
0,2	0,3	0	0	0,3	0,2
0,2	0,3	0	0	0,2	0,2
180"
0,2	0,3	0	0	0,2	0,2
0,2	0,3	0	0	0,3	0,2
300"
0,2	0,3	0	0	0,3	0,2

SVP 450 PLUS - SVD 500 PLUS

4.6 Projector centering

The first step towards a good installation is centering the projector with respect to the screen. This can be done using two pieces of equally long cord, as illustrated in the following figure:

		SCREEN
	CORDS OF THE SAME LENGTH
			AND PROJECTOR	CENTRE
Reference			SCREEN		Reference
corner					corner

It is necessary to check that the position of the two corners at the front of the projector is centred with respect to the position of the cords, as illustrated in the figure.

Once you have done this you can be sure that the screen and the projector are orthogonal and centred, essential conditions for the best performance.

4.7 Optical and electrical adjustments

Turn the projector on with the main switch on the left of the rear panel; the red pilot light indicates the stand-by state.

If the projector remains in stand-by press the button on the remote control or the or arrow buttons on the rear panel. The green pilot light indicates the projector is on.

To turn the projector off, press or the main switch.

Proceed with installation using the internal test patterns. They can be used by pressing TEST on the complete functions remote control (RC3000) and selecting the most appropriate test signal.

ENGLISH

21